Getting error while deploying policy on firepower
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-08-2022 09:15 AM
Firepower running on version 6.4.0
Getting below error while deploying the changes-
Error resolving rule (15) : user configured dest networks but none were found.
I am not sure but I think it is related to rule 15, have attached the screenshot.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-08-2022 09:20 AM
@engineer467 I've not seen this error before. Had you configured rule #15 with the destination object and subsequently deleted the object perhaps? If not upgrade, 6.4 is very old and loads of bug fixes since then.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-08-2022 09:23 AM - edited 07-08-2022 09:24 AM
Hi Rob, destination object is present.
strange thing is Even if i try to delete it, or edit it, it gives back the error-
Error resolving rule (14) : user configured dest networks but none were found
So this time there is error in rule 14.
perhps u r right, an upgrade might fix it.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-08-2022 10:22 AM
Can i go to 7.0.1 directly from 6.4.0??
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-08-2022 10:32 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-08-2022 10:39 AM
I don't have a lot info. about firepower but are the IP you use as source is reachable by DMZ-zone ?
