How to configure ACP from FMC API Or Postman
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-13-2021 12:34 AM - edited 09-13-2021 12:35 AM
Hi All,
I have a big problem.
I am migrating a Cisco ASA 5545, to FTD 2130. ASA is containing 150 Tunnels of Site-2-Site VPNs.
Migration tool version 2.4 support migration of tunnels but still it does not support ACLs migration that we have under 'vpn-filter Tunnel group'.
it means I have to configure about 900 lines of ACP manually.
I am searching if it can be a Copy-paste solution on FMC API or maybe using Postman. ( to decrease human configuration error)
it would be my appreciation if somebody has experience of that?
and so especially maybe @Marvin Rhoads can have approached... thanks in advance
Regards
Ashkan-Mohammad Najarian
Scanplus GmbH
ULM-Germany
CCIE #65604
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-14-2021 01:58 PM
Go to https://your_fmc_ip/api/api-explorer/ and that will take you to the API explorer that will give you plenty of examples to run with.
Thank you for rating helpful posts!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-14-2021 11:05 PM
You can start with these links.
https://blogs.cisco.com/security/how-to-get-started-on-programming-firepower-using-fmc-apis
https://www.youtube.com/watch?v=-e0bNF3q0Kg&ab_channel=JayantThakre
https://www.cisco.com/c/en/us/td/docs/security/firepower/620/api/REST/Firepower_Management_Center_REST_API_Quick_Start_Guide_620.html
**** please remember to rate useful posts
