initial network config in FMC

[Ibrahim Jamil]

Hello freinds

in FMC Cli , what command do i need to enter to see the initial network config , for ex in ngips its "sh network"

thanks

[mikael.lahtela]

Hi,

FMC is linux based OS, so you don't have the regular "show" commands in there.
You can use commands like "ip address", "ip route" or other linux commands.
But I would not recommend to poke around too much in there in a production environment if not needed.

br, Micke

[Ibrahim Jamil]

what is the equivalent of " sh run" in fmc , i have to see the how the network config looks like from cli