I have a 4260 with the latest software and I know it is rated at 1 - 2 Gbps (transactional / media rich) throughput. I have it monitoring a 400 Mbps pipe that is pretty well maxed out at 400 down and 100 up during peak times for a total of 500 Mbps throughput. My CPU Usage shown in the 4260 management GUI gets as high as 80% at peak times. Should it be that high for this unit with that amount of traffic?
Thanks for positng. Actually when you are talking about traffic through the box and the performace of the IPS, you should focus on the "Inspection load". If the inspection load is too high you will start seen missed packets and overruns on the interfaces.
Chances are that maybe with low amount of traffic the CPU can be high since it handles many process and it uses a different algorithm to calculate the value.
I recommendation will be to focus on the inspection load.
HIDoes anyone know if there is an easier way than the belowQ. I check connection events for IOC's when requested and sometimes i have to check many url's which i am presently doing one url at a time and is very time consuming, is there a way to check mult...
Cisco Identity Services Engine (ISE) gives you intelligent Integrated protection through intent-based policy and compliance solution. ISE supports external MDM vendor integration to help the customers to look for compliance of a dev...
This video provides the steps to configure the Cisco Threat Response (CTR) and ESA Integration.
This is live on the portal:https://video.cisco.com/video/6159336218001
And on YouTube:https://www.youtube.com/watch?v=UCKIdx5rdFg
I need to migrate from C170 to C190 and have already match to the same Firmware Version. I have a question. Is there any method that can export and import the configuration file instead of form cluster ?