LILO Keytable read/checksum error

[David Ettinger]

I am attempting to install a FMC virtual appliance (Cisco_Firepower_Mgmt_Center_Virtual_KVM-7.0.5-72.qcow2) on my Redhat 8 computer.   When I run my installation script to configure the VM and boot I get a "LILO Keytable read/checksum error" immediately.    I have used this qcow2 image and the installation script on two other computers without a problem.   I've attached my installation script (I changed the extension to .txt for upload).

[Flavio Miranda]

Hi

 You may take a look on this link. This is for Slack but you may try in RedHat and see what happens.

https://www.linuxquestions.org/questions/slackware-14/lilo-keytable-read-checksum-error-4175520197/

[David Ettinger]

Thanks Fliavio.   I saw this solution.    I've been around Linux a long time but have never really had to deal with lilo so I don't really know what this means.   I just don't understand how I could install off the shelf Cisco VM on two different laptops (one didn't even support virtualization but the FMC VM still booted) but it won't run on two different server machines that are already running KVMs.   Are their BIOS setting that might have something to do with this?   I'm dead in the water until I can solve this.