I have 2 Pix 515 in production at our main facility here in Paris
One is a backup solution with 6.2(2) software
Here is the show version :
Cisco PIX Firewall Version 6.2(2)
Compiled on Fri 07-Jun-02 17:49 by morlee
FW-GLI up 30 days 19 hours
Hardware: PIX-515, 64 MB RAM, CPU Pentium 200 MHz
Flash i28F640J5 @ 0x300, 16MB
BIOS Flash AT29C257 @ 0xfffd8000, 32KB
Licensed Features:
Failover: Enabled
VPN-DES: Enabled
VPN-3DES: Disabled
Maximum Interfaces: 6
How can i enable the VPN-3DES ??
Is it free ? ;)
Now main problem : our main Pix is software 4.4 "only"
here's the show version :
PIX Version 4.4(4)
Compiled on Thu 06-Jan-00 16:07 by pixbuild
PIX BIOS Cisco Secure PIX Firewall BIOS
FW_GLI up 108 days 14 hours
Hardware: PIX-515, 64 MB RAM, CPU Pentium 200 MHz
Flash strata @ base 0x300
Licensed Options:
Failover: Enabled
IPSec: Disabled
Ports allowed: 6
I must set up VPN for client access very soon...
My setup use 4 zone and both Pix have 4 ethernet ports.
Can i upgrade the 4.4 to ver 6.3 ??
I have enought memory but the 6.3 needs an activation key to enable more then 3 zone...
How will i get an activation key for my old firewall ??
Thx for reading !
