I have installed a third nic into my pix-520. Does the pix automatically recognize it? I tried the interface command, the results are below:
interface ethernet2 auto
Could not recognize hardware identifier "ethernet2"
Boot messages are below:
Rebooting....
Cisco Secure PIX Firewall BIOS (3.6)
Flash=i28F640J5 @ 0x300
Reading 2445824 bytes of image from flash.
128MB RAM
Flash=i28F640J5 @ 0x300
BIOS Flash=AT29C257 @ 0xfffd8000
mcwa i82558 Ethernet at irq 11 MAC: 0090.2744.fc93
mcwa i82558 Ethernet at irq 10 MAC: 0090.2757.021f
-----------------------------------------------------------------------
|| ||
|| ||
|||| ||||
..:||||||:..:||||||:..
c i s c o S y s t e m s
Private Internet eXchange
-----------------------------------------------------------------------
Cisco Secure PIX Firewall
Cisco Secure PIX Firewall Version 6.0(1)
Licensed Features:
Failover: Enabled
VPN-DES: Enabled
VPN-3DES: Disabled
Maximum Interfaces: 6
Cut-through Proxy: Enabled
Guards: Enabled
Websense: Enabled
Throughput: Unlimited
ISAKMP peers: Unlimited
thanks
