cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1435
Views
0
Helpful
4
Replies

Policy based routing

RexPr
Level 1
Level 1

Following documentation (https://www.cisco.com/c/en/us/td/docs/security/asa/asa94/config-guides/cli/general/asa-94-general-config/route-policy-based.html) I'm trying to configure policy based routing on ASA 5506-X (9.8).
The steps seem are simple:
- define access list
- define route-map
- match ip address to acl
- set next hop
then associate to interface:
- interface GigabitEthernet 1/x
policy-route route-map ...

but after entered on interface config policy-route route-map command doesn't exist.
This is the help:
CiscoAsa(config-if)# policy-?

configure mode commands/options:
policy-list policy-map

there is no policy-route command.

where is my mistake?

Thanks,
Fabrizio

Fabrizio www.rfc.it
2 Accepted Solutions

Accepted Solutions

perhaps it requires a security plus license?

azam

View solution in original post

Solved. The problem was the use of BVI.

Policy based rules are not working with an interface based on BVI.


Fabrizio www.rfc.it

View solution in original post

4 Replies 4

Roy Harrington
Cisco Employee
Cisco Employee

Can you provide the output from "show ver | i plat|image"

CiscoASA# show ver | i plat|image
System image file is "disk0:/asa982-lfbff-k8.SPA"
Licensed features for this platform:
This platform has a Base license.
Costa-PR#

 

Fabrizio www.rfc.it

perhaps it requires a security plus license?

azam

Solved. The problem was the use of BVI.

Policy based rules are not working with an interface based on BVI.


Fabrizio www.rfc.it
Review Cisco Networking for a $25 gift card