problem upgrade FW1 1010 via FMC

[Dhikra Marghli]

Hello

i have  HA FW  CISCO 1010 ..so  i want  to upgrade  the two  FW  active passive with  FMC 4000. 

yesterday , the update is performed only on the FW2    but the upgarde is not  performed in FW1 !!!?

FW2  will  be  70.4

but FW1 is still  6.6.1

you will  find a picture  about HA  FW

so  how i can resolve the problem  upgrade  for FW1  and i need a solution  that i can upgrade FW1 to 7.0.4 !!

Thanks in adv

.

[Marius Gunnerud]

The upgrade is not performed on the primary FTD because the secondary FTD is showing as "failed".  Investigate and correct the issue that is causing the secondary to show as failed and run the upgrade again.

[Dhikra Marghli]

Hello

thanks to reply me

but i reply more time  for FW1  and the upgrade is failed 

so what i can doing to resolve problem upgrade HA 1010 cisco

i wait a help and a solution

thanks

[Marius Gunnerud]

Sorry, but I do not understand what you meant by your previous post.

As I mentioned in my first post we need to find out why your primary device is showing as "failed".  Run the following commands and post the output here

show failover

show failover history

show run failover

show int ip bri