UDP flooding, 2 routers and PIX

[m.teplov]

Hi Guys!

Question:

2 routers with 2 FE interfaces each and PIX between

them. Flow is unidirectional. Firewall is neccessary

at this point.

>--FE--R--FE--PIX--FE--R-->

According to the document:

http://www.cisco.com/univercd/cc/td/doc/cisintwk/ics/cs006.htm

I can forward broadcasts from ethernet of one router to another ethernet of another router. I'm not shure that this configuration is possible on the PIX. It must pass this traffic.

Somebody do so?????

Best regard Matvey Teplov.

[millerv]

If you know the udp port numbers it would go a long way, i flooded udp by using the helper address .

If the destination address is on the far side of the

pix you could try that. along with the forward protocol statement. (see the ios doc) Other wise

its an access list