Upgrade FTD 2130

[osn]

firepower-2130 /firmware # download image
ftp: Location of the image file
scp: Location of the image file
sftp: Location of the image file
tftp: Location of the image file
usbA: Location of the image file

firepower-2130 /firmware # download image usbA:/Cisco_FTD_SSP_FP2K_Upgrade-7.4.2-172.sh.REL.tar
Please use the command 'show download-task' or 'show download-task detail' to check download progress.
firepower-2130 /firmware # show download-task

Download task:
File Name Protocol Server Port Userid State
--------- -------- --------------- ---------- --------------- -----
Cisco_FTD_SSP_FP2K_Upgrade-7.4.2-172.sh.REL.tar
Usb A 0 Failed
fxos-k8-fp2k-firmware.1004.0103.0211.SPA
Usb A 0 Failed
firepower-2130 /firmware #

It says in downloadnig task that is nor enough disk space ?? 

I have it on a usb and it is fat32 

[osn]

Here it says 

Download task:
File Name Protocol Server Port Userid State
--------- -------- --------------- ---------- --------------- -----
Cisco_FTD_SSP_FP2K_Upgrade-7.4.2-172.sh.REL.tar
Usb A 0 Failed
fxos-k8-fp2k-firmware.1004.0103.0211.SPA
Usb A 0 Failed
firepower-2130 /firmware #

[Marvin Rhoads]

We don't upgrade FTD on a 2100 series using the fxos cli. Instead, we upgrade via the management GUI - Firepower Device Manager (FDM) if it is locally managed or Firewall Management Center (FMC) if is is centrally managed.

[osn]

It has been erased and it should connect to a new fmc. 

[Marvin Rhoads]

If it is totally erased, then you would not have fxos to connect to. You would instead follow the reimage procedure and use the install package (e.g., cisco-ftd-fp2k.7.4.2-172.SPA), not the upgrade package.

https://www.cisco.com/c/en/us/support/docs/security/firepower-1000-series/220642-reimage-a-secure-firewall-threat-defense.html

https://software.cisco.com/download/home/286312107/type/286306337/release/7.4.2

[osn]

I have done that same response 

the one I tried was cisco-ftd-fp2k.7.4.2-172.SPA with same result 

[Marvin Rhoads]

Did you check "show package" to see what (if any) other images might be present in fxos' file system? We don't normally see them not have sufficient space, but it can happen. But if you did a "factory-reset" from rommon that should have cleared out old images.

If it still fails, Cisco TAC would be best equipped to look at it more closely with you.

[osn · Accepted solution]

I have check and delete some file but the problem remains. I will try a factory-reset tomorrow