01-13-2005 05:18 AM - edited 02-20-2020 11:51 PM
Hi,
I want to configure port security on a switch into which a failover PIX pair are configured. However, from
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/12_1e/swconfig/port_sec.htm
it appears that this may not be possible due to the PIXes swapping MAC addresses: 'If a workstation with a secure MAC that is address configured or learned on one secure port attempts to access another secure port, a violation is flagged.'
Does anyone know of a way around this?
Many thanks in advance,
Matt
Solved! Go to Solution.
01-13-2005 06:06 AM
Hello Matt,
Unfortunately there is no work-around to your problem.
Thanks,
Mynul
01-13-2005 06:06 AM
Hello Matt,
Unfortunately there is no work-around to your problem.
Thanks,
Mynul
01-13-2005 07:54 AM
OK - thanks Mynul
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: