VPN 3005 concetrator https access

[Marcin Zgola]

I was able to access the vpn concetrator using https session on private interface. After I save the config file or did something. When I do http I am getting webvpn login screen littile different than the one thjat i was getting. The other one had vpn cisco picture on the right. this one is jjust plain webvpn screen and the username and password doesn;t wok (it works in telnet session(. How do i get the old screen back. thank you

[gudmo]

You need to telnet into your box and enable HTTPS access and disable WebVPN

Do this by going into Configuration -> Interface Configuration -> 1) Configure Ethernet #1 (Private) -> 10) Set Interface WebVPN Parameters

Make sure HTTPS is enable here -->1) Enable/Disable HTTP and HTTPS Management

And this is disabled --> 2) Enable/Disable HTTPS WebVPN