VPN3002 - Split Tunnels

[nortonp]

Will Split Tunneling work when using a VPN3002 Hardware Client in Network Extension Mode? I have enabled Split Tunnelling on the 3030 Concentrator. It seems to tunnel the correct networks but it doesn't send the networks in the bypass list to the internet.

I've tried both "Allow networks to bypass..." and "Only tunnel networks in list"

[gfullage]

Split tunnelling should work exactly like it does for the SW client. On the 3002 under Monitoring - System Status you should see IPSec tunnels built for the specific split tunnelling networks (in the Remote Address column).

On the head-end concentrator, just select the "Only tunnel networks in the list" option and select the split tunnel network list. Of course make sure this is under the Group properties that the 3002 is set up to connect into.

[nortonp]

I do see the tunnels built for the networks defined for split tunneling. The problem is that any network not defined doesn't go out the internet.