10-31-2020 07:25 AM - edited 10-31-2020 07:25 AM
Hello all,
I have 2 ASA connected with a similar configuration than the attached file. If I need to connect, let´s say, 10 more ASAs between them (full mesh). What is the easiest way to do it? I have to create new tunnel-group and a interface for each VPN?
Thank you
Solved! Go to Solution.
10-31-2020 07:43 AM
Hi @javi1988
Yes, you are correct. Unfortunately there is no Dynamic VTI on the ASA, so you'll need to define 10 x VTI, tunnel-groups and static route(s).
If you used a router instead of an ASA, you had the option to either using FlexVPN with Dynamic VTI or DMVPN, to build a Full Mesh design.
HTH
10-31-2020 07:41 AM
GETVPN check this protocol as solution.
10-31-2020 07:43 AM
Hi @javi1988
Yes, you are correct. Unfortunately there is no Dynamic VTI on the ASA, so you'll need to define 10 x VTI, tunnel-groups and static route(s).
If you used a router instead of an ASA, you had the option to either using FlexVPN with Dynamic VTI or DMVPN, to build a Full Mesh design.
HTH
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: