Having a switch from Cisco: SG300-52, It functions only from a web gui, no cli available which has made configurations cumbersome.
We don't see a tab for assigning an IP Address to a VLAN under "VLAN Management".
This document will attempt to track known reasons and workaround/fixes for this error.
Our intended goal via the web gui is: Switch(config)#interface Vlan2 Switch(config-if)#ip address 10.x.x.x 255.255.255.0
Switch runs in Layer 2 mode by default. If we want to put ip addresses on the vlans, need to change the switch mode from Layer 2 mode to Layer 3 mode. We can ONLY do this in the console menu (not the web GUI). It does indeed exist, you must access it using a baud rate of 115,200 (not the standard 9600), data bits = 8, parity = none, stop bits = 1, flow control = None. It is also available via telnet (default username/password is cisco/cisco). Go to Switch Main Menu --> System Mode.
NOTE: Switching between Layer 2 & Layer 3 modes will clear all other configurations that you have in place, so plan accordingly.
You should be able to address the vlans after you've made this change.
Hi Everyone, Anyone can help me about my issue right now, we are trying to ping vpn.catonetworks.net from our gateway router but using our Public IP's results to have very high latency. The public IP where ISP provided by ISP looks very g...
Hi team,Can anyone confirm the answer for this question?My answers are below but need to be verified by someone. Router4#conf trouter ospf 0.0.0.2 area 0.0.0.1 virtual-link 10.1.2.1 255.255.255.0end Router3#conf trouter ospf 0.0.0.1ar...
I am planning to implement guest WiFi access in my network.Already we have the Cisco AP & WLC in place. The existing Cisco AP has 1 SSID for intra WiFi access.The WLC is in the Data center & the APs are in branch locations.I want to setup addition...
In my L3# Switch I have a default route pointing to internet.ex: 0.0.0.0 0.0.0.0 next hop<x.x.x.x> So by default for any traffic not in the routing table, it will follow the default route.But would like to know , whether the static/default rout...
Hello,I am looking at replacing an old site router (non-Cisco) with a Cisco C1111-8PLTELA. Due to the remoteness of the site they aren't able to get a high bandwidth WAN connection, so currently they are using 4 (2x LTE 2x VDSL) and the existing rout...