Script executes IOS commands, matches the result against patterns to extract numeric values to be published via SNMP Expression MIB.
Script Modified Date:
May 05, 2010
Cisco IOS Version tested:
Cisco Products Tested:
Environment Variables used:
Script Info URL:
CliValueToSnmpExprMib executes one or multiple IOS commands and matches one or multiple regex patterns for extracting numeric values from the command outputs. The configuration section after the script header allows the specification of > commands > patterns for extracting the interesting values > Expression MIB OID indexes for each value The script creates Expression MIB entries unless it exists already. Otherwise it will just its value. The script efficiently deals with multiple commands. It executes all commands in one go, does all the value extractions, and finally updates all expression MIB entries together.
two fiber trunks connect an Intermediate switch (3850 stack) to our Core switch (6500). They are setup as a port channel (ON).one of the links has died (not connected). I have performed "shut" "no shut" &...
On one of our Cisco 9300 switches some of the ports have stopped working. The show as not connected despite the fact they are. On three of these ports TDS is constantly running since yesterday. The devices connected to interfaces Gi1/0/13 and Gi1/0/1...
hi all, i have two cisco switches (4510 and a SG350X) connected together via LACP 2x1g either side so 4x1g one side is an "active" (4510) connection and the other side is set to "auto" (SG350X) and both port channels either end say "connected" i...