Disable STP and Cisco GigaStack

Views

Helpful

Comments

edited on: ‎03-01-2019 ‎04:39 PM

HI,

I have two questions about stp

1) I have Cisco GigaStack GBIC in mode halft-duplex. Can I enable rapid spanning-tree? Does Rapid spanning tree need link full duplex?

2) If I disable STP, Would root bridge be created? Would bpdu be exchanged between switches? How to work the switches without stp?

Latest Contents

%PHY-4-SFP_NOT_SUPPORTED: The SFP in Gi0/11 is not supported...

Created by Vishauk47 on 07-23-2019 06:54 PM

Hi Guys, I am getting the following error while creating the trunk link between 3650 48 ps to 3560cx-12 ps switch %PHY-4-SFP_NOT_SUPPORTED: The SFP in Gi0/11 is not supported Have tried the commands but no luck, any suggestions ... view more

DHCP (Pool/Server) Clarification on GS300

Created by ylafont on 07-23-2019 05:08 PM

Host Use the ip dhcp pool host Global Configuration mode command to configure a &n... view more

BGP and advertising 2 /25 as a /24

Created by dave.clark on 07-23-2019 04:58 PM

We split a /24 into two /25 segments:eth 1/1 - 8.23.2.0/25eth 1/2 - 8.23.2.128/25eth 1/3 - 8.8.2.2 - ISP link So the whole /24 lives on the router, but split. When I advertise 8.23.2.0/24 to ISP, it doesn't show up as and advertised route. Is there a... view more

WCCP with multiple redirect list

Created by hayesd on 07-23-2019 02:00 PM

is it possible to add more than 1 ip wccp redirect on a vlan interface ? Each one with a different associated access list, will both redirect access list be searched for a match ? interface Vlan903ip address 10.250.1.21 255.255.255.252ip wccp 5 redir... view more

PT 7.2.1 EIGRPv4 & OSPFv3

Created by knichel on 07-23-2019 12:08 PM

Not sure why my post ended up here rather than in the Network Academy forums... I removed the content.

CreatePlease to create content