When you configure a guest VLAN, clients that are not 802.1x-capable are put into the guest VLAN when the server does not receive a response to its EAPOL request/identity frame. Clients that are 802.1x-capable but fail authentication are not granted access to the network. The switch supports guest VLANs in single-host or multiple-hosts mode.
The guest vlan is supported on these switches:
Catalyst 29XX series switches
Catalyst 35XX series switches
Catalyst 3750 series switches
Catalyst 4500 series switches
Catalyst 6500 running CatOS system software
Note: Catalyst 6500 running Cisco IOS or Native platform does not support guest VLAN and auth-fail VLAN as for now.
Hello everyone, I have a 3750 stacked core switch (1x 3750G and 2x 3750v1) that works perfectly. It does all the routing inside my LAN and it also leases all my DHCP addresses. The problem that I'm having is that my devices on my access switches (1x ...
Our 911 center purchased a RV320 to be used solely for 4G internet access via ethernet connection. On the compatibility list includes Verizon's new USB730L. Trying to set it up and it doesn't seem to recognize the device. Contacted Veriz...
We have Cisco DX80 set up to acquire IP Address via DHCP and It's connected to a switchport. I also configured a Static DHCP on our cisco 2911 router for the DX80. The switchport is correctly configured with the right vlans and all service vlans are being...
HI community, im having issues to understand why this QoS is behaving like this.router is 4331/k9 my understanding is since the main Policy(parent) is CBWFQ it assigned up 50% and 40% to the class in the main. then the remaining BW is assigned to the...
I am getting confused with the input output rate of an interface, how can my input rate be less than my output rate? example below:Load-Interval #1: 30 seconds30 seconds input rate 11246640 bits/sec, 20009 packets/sec30 seconds output rate 165052558...