This configuration is desired when there are two DHCP servers on the network, and IP helper addresses are configured for each server. However, only one server receives most of the DHCP address requests.
In order to verify that only one server receives most of the requests, it is necessary to perform a sniffer trace on the ports connected to DHCP servers.
If there are multiple DHCP servers, load balancing is not possible because the DHCP client PC-broadcasts a DHCP discover packet sourced from 0.0.0.0 and destined for 255.255.255.255. By default, the router blocks all of the broadcasts packets.
HelloRecently installed EHWIC-4SG in Cisco 2901 router with v.15.6, when tried to adding IP to one of WIC port get the below error:% IP addresses may not be configured on L2 linksHow to assign IP to the ports Thanks
Hello,i have N5k-5548UP-AF and i have mikrotik router connected to this unit and my tunnel has been establish over that mikrotik tunnel but i need to adjust tcp mss on my n5k-5548up-af side, is there nayway to do this?Thank you.
Hi guys Thanks for an awesome resource! A quick question related to BGP and NEXT-HOP-SELF. We have a classic WAN setup with two separately running border switches. They run EBGP towards a firewall setup and IBGP between each other. There i...
Hi,we have enabled L3 routing (BGP) at Nexus9000 93180YC-EX but I cant find any related documentation for the maximum throughput that box can handle or even from the CLI itselfyour help is appreciated.