The SPAN reflector feature enables multicast traffic as well as other traffic that requires central rewrite engine to be switched when it comes from the Firewall Service Module (FWSM). For example, for each FWSM in a switch, the SPAN reflector feature is enabled. This feature uses one SPAN session.
In order to enable the SPAN reflector feature, use the monitor session servicemodulecommand and in order to disable or delete a session, use the no form of this command
Note: If you have a fabric enabled Supervisor card and you disable the span you will loose all multicast, GRE, and Distributed Etherchannel traffic that is transiting the FWSM. Thus it is recommended that you do not disable the span reflector.
I just bought myself a 7206VXR for my home lab. This is replacing a typical home router, but I'm curious about the NAT configuration Say the interface that connects to the ISP is x.x.x.xThe interface that connects to the house is 192.x.x.x ...
I'm using version 16.3.7 of the C3650.increase the logging buffer size to 16000 andIf you increase the logging buffer level to informational, the size goes back to 4096.Are there any setting criteria that I do not know?
Hi there, I want to setup send syslog from a router(public ip) to SNMP server(private ip). I've successful setup sending syslog from another router(private ip) to snmp server(private ip). Do I need to do special con...