A router can continually display the log messages because the service config command is enabled on the router.
These error messages usually occur after the router has performed a Cisco IOS Software upgrade. In the latest version of Cisco IOS Software, the service config command is the default value. Since this is the default value, the service config command line sometimes does not show up in the showrun command output.
To disable the serviceconfig command on the router and stop the log messages from being generated, perform these steps:
Issue the no service config global configuration command, as shown:
Enter configuration commands, one per line. End with CNTL/Z.
router(config)#no service config
Issue the write memory or copy running-config startup-config command.
This is a sample command output:
router(config)#^Z!--- Enter ctrl-z to get back to the main prompt.
We have two Nexus 9000 (C93180YC-FX) that we need to connect to a WS-C3750X-24S. The vendor who sold us the switches said that all we needed was to install the transceivers and set the speed to 1000. I installed the transceivers, connected them via a...
Can someone confirm if the Cat8300 supports (or will support) GLBP ?I thought I saw it mentioned in the 8300 datasheet somewhere, but looking in Feature Navigator, it did not show up under the DNA Advantage license selection.. Although I did see the ...
Community Live- ISR1100X-4G and ISR1100X-6G Platform Overview and Architecture
(Live event - Tuesday, 23 March, 2021 at 10:00 am Pacific/ 1:00 pm Eastern / 7:00 pm Paris)-
This event will have place on Tuesday 23rd, March 2021 at 10:00 hrs PDT&...
Hello everyone,I'm setting up a lab with inter-vlan routing. I have a host in VLAN 50 (192.168.50.0/24) and 3 SG220 switches in the Management-VLAN Vlan 30 (192.168.30.0/24). A Cisco 1941 Router is doing the routing between the VLAN's. Everythin...
Dears,Kindly I need your help in the problem with the below details:Router PID: Cisco ISR4221/K9Image: isr4200-universalk9_ias.16.09.04Error Code: %Address 0.0.0.0 is not validSymptoms: Causes cellular interface's state to keep switching between up and do...