This document provides a Troubleshooting Spanning Tree Best Practice. for ... (this introduction should provide a description of the subject matter and any contextual information describing a real-world scenario in which this information might be used).
There are no specific requirements for this document.
Ensure that you meet these requirements before you attempt this configuration:
This section describes the information you need to configure the features described in this document.
This document uses this network setup:
This document uses these configurations:
Use this section to confirm that your configuration works properly.
Hi. Sorry for my English I have this problemI have this switch: WS-C2960G-24TC-L (c2960-lanbasek9-mz.122-55.SE.bin) I am injecting multicast traffic to interface giga0/19, but it does not come out through the interface Port-cha...
Hello: Have a situation where we're trying to do some NAT'ing with an RV160-K9-NA, using only the LAN ports; there is no connection to the Internet via the WAN port. The setup: We have an interface device (a Schneider Electric ST65...
Hello, When I recently became unable to print on my LAN, and I did some troubleshooting, I realized that 3 copies of the Anyconnect Socket Filter load automatically after each restart, without me having to run the Anyconnect app. It occurs...
Can someone please point me to the right direction as to why my tunnel is not coming up?My configuration looks like this:explicit-path name PATH1index 1 next-address ipv4 unicast 172.16.0.4index 2 next-address ipv4 unicast 172.16.0.7index 3 next-address i...
I'm new to the firewall world. I have a firepower 1010 using the Fire Power Management Device (22.214.171.124-13) for a home lab. I created two subinterfaces and configure OSPF but one of them is not able to communicate. They both have the same configuration but...