Encapsulating IEEE 802.1Q VLAN tags within 802.1Q enables service providers to use a single VLAN to support customers who have multiple VLANs. The IEEE 802.1 QinQ VLAN Tag Termination feature on the subinterface level preserves VLAN IDs and keeps traffic in different customer VLANs segregated.
Some ambiguous subinterfaces can use the any keyword for the inner VLAN ID specification. The any keyword represents any inner VLAN ID that is not explicitly configured on any other interface. In the following example, seven subinterfaces are configured with various outer and inner VLAN IDs.
The any keyword can be configured on only one subinterface of a specified physical interface and outer VLAN ID.
The encapsulationdot1qsecond-dot1q any command is supported only on a subinterface configured for Layer 2 (Ethernet over multiprotocol label switching [EoMPLS]) tunneling. If you use the encapsulationdot1qsecond-dot1q any command on a subinterface not configured for EoMPLS tunneling, all incoming packets are dropped without generating an error message.
The any keyword in the second-dot1q command is supported only for Point-to-Point Protocol over Ethernet (PPPoE) QinQ traffic.
It is not supported on a subinterface configured for IP over QinQ because IP routing is not supported on ambiguous subinterfaces. Therefore, multiple values and ranges for the inner VLAN ID are not supported on IP over QinQ.
Good Day Please advise i have switches which i have configured SVIs see below command snippet. When i try to access the switches i am not able to ssh or even ping the switches. interface Vlan1ip address 192.168.3.205 255.255.255.0!!i...
Hi, I want to create a rule for a specific port on a 3650. I want to allow all traffic within a VLAN (lets assume VLAN 10, ip address 192.168.178.254 255.255.255.0) expect for one host (lets assume ip adresse 192.168.178.100). This IP adre...
Hi,I need to extend a temporary switch inside our network. There is no need for SGTs/Segmentation and my only requirement is to extend a VLAN on a new switch and have hosts plug into the new switch. From my understanding, this should just be a ...
I saw the following statement in the document below. [document]'https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/93x/layer-2-switching/configuration/guide/b-cisco-nexus-9000-nx-os-layer-2-switching-configuration-guide-93x/b-cis...
Hello, I am configuring remotely some switches 9500For this a laptop is connected to the Console port of the switch.Console port opens fine using standard values from Putty Terminal. But when the terminal has to show several lines, the laptop crashes, reb...