ssh & PDM

[hossk]

Hi,

I need to set up ssh tunnel between a ssh client and PIX. But i want to configure the PIX using PDM(https port). IS it possible? I am limited by the fact that there is a firewall in between and only ssh port is allowed from the ssh client to the PIX.

thanks in advance

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.