Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, is there a way to reset the Interface Status under Interfaces- Monitor in Stealthwatch 7.1.2?Currently seeing "Interface Status (Since Reset Hour)" - not sure what this means..Thanks,
hi experts one question about the ad integrationnow it's partially working but the client have a doubt about the photo sectionit's possible to put a photo of the ad users in that section? like in the snapshot that i uploaded?i hope you can give me s...
Have you enabled Early Access in Cognitive Intelligence? It gives you access to Alert Fusion, the most significant overhaul of Cognitive Threat Analytics in the last five years! By increasing the relevance of alerts through smart grouping, and allowi...
Hi good afternoonI should configure Cisco ISE RTC with Stealthwatch. I would like to know how should I use plus license (for pxgrid)?.I have 1000 base license, my question If I only use Cisco RTC without profiling, Should I purchase only 100 or 1000 ...
Hi Team, Is there any configuration guide for Endace integration with StealthWatch. May I know what are the prerequisites to achieve this integration like:1. Stealthwatch and Endace supported version 2. Is deploying Stealthwatch Flow Sensor Virtual o...
My team needs to monitor both our AWS network and our on-prem network. We are currently using cloudwatch for our AWS resources and we want to integrate our on-prem gear to cloudwatch. Our on-prem network consists of ASAs, Switches, and CentOS server...
We a have provide Cisco Stealthwatch X710-DA2 dual-port 10G SFP+ NIC on FC4210 and SMC2210 10G interface. So Can we used 10G SFP+ Port for Management and Collection
Hi,I have a question:Does CISCO ASR is able to support a peer that has node which has end entity Certificate based on ECDSA ciphers but signed with CA certificate based on RSA ciphers? I am using ASR1006 with Cisco IOS XE Software, Version 16.06.03.B...
hi experts, i have a little problembecause some client has stealthwatch and want to integrate it with ADthe integration is fine from i stealthwatch(we are using the same user type that we use for ISE to get data from the same AD) following this docum...
Hi, I am new to Stealthwatch and have some questions which I cannot find in the other discussions in the community forum. We have a small deployment at one of our customers with 1 SMC and 1 FC. It is a multi-vendor environment. We have cisco, palo al...
If a infrastructure device (router, switch) is capable and enabled for Encrypted Traffic Analysis - will east/west traffic within an environment be reported on? It was my understanding that ETA was specifically for traffic between the Inside and Outs...
Hi Guys We've recently updated to Stealthwatch v7.1.2 are we're currently trying to activate the CTR integration using the below guide. https://www.cisco.com/c/dam/en/us/td/docs/security/stealthwatch/ctr/SW_7_1_2_Stealthwatch_and_Threat_Response_Inte...
We just got a new FlowCollector and we reconfigured a few exporters to send Netflow data to the new FlowCollectoris there a way to move the data collected to the new flow collector ? or delete all of them for that Flowcollector in batches instead of ...
