Once the console connection is established, use the set ip command and press Enter.
Provide new information, such as the IP address, and use the reboot command in order to reboot the ACS SE.
After the backup ACS SE works. Log into GUI and confirm these:
On ACS hardware/appliance, choose NIC Configuration > Reports and Activity > Appliance Status Page. Copy the IP address of the ACS SE.
Choose Interface Configuration > Advanced Options. Check Distributed System Settings and press Submit.
Choose Network Configuration > AAA Servers > Search. Type the IP address of the ACS hardware/appliance and choose Search. Note down the Name against the IP address of the ACS SE.
Choose Network Configuration >Proxy Distribution Table > (Default). Make sure that the name that appeared against the IP address of the ACS hardware/appliance is in the Forward To column. If it is not, move it, and move all other entries under AAA Servers column and choose Submit + Restart.
Hello TogetherPlease i will open for LAN "Inside" the SSH Port. try with this commands but no postive result appair "Connection redused"i know iam on the right way, please and thanks for any Update:asa(config)# crypto key generate rsa general-keys modulus...
Hi all !I'm capturing Audit logs from FMC using tcpdump, but unfortunately I do not see any access policy changes in the logs : \I do get other logs like saving the configs etc, but when I edit the policy and add/remove/edit a rule , I get nothing on the ...
I am about to uprade two FTD 4110 FXOS. The first upgrade has been succeced on the Secondary and then I tried do run the same steps on the primery FTD. I has been runing upgrade in more than 2 hours on the primery FTD now and I am soure that some thing is...
Hello Community I'm following the doc https://www.cisco.com/c/dam/en/us/td/docs/security/content_security/virtual_appliances/Cisco_Content_Security_Virtual_Appliance_Install_Guide.pdf we have 3 interfaces for the virtual appliance. During c...