(In the 3rd command, that’s “sl” as in “session list”). (Username: Netcrypt / Password: Netcrypt). When you’re done, exit out using Ctrl + ] then type “quit” at the “telnet” prompt.
If they’re just replacing a Netcrypt, it’s just like replacing a QAM except you have to change 5 MAC addresses. The only trick is that there’s a huge label on the bottom of the Netcrypt with 10 MAC addresses. They’ll need to get the 1st, 3rd, 4th, and 5th MAC address off the bottom of the unit BEFORE racking it. (There’s a picture of the label on page 2-5 in the attached document “Netcrypt Bulk Encryptor Hardware Installation and Operation Guide", P/N 4001444 Rev B.) These MAC addresses are labeled as follows:
MAC ETH A MAC CH 0 MAC CH 1 MAC CH 2 MAC CH 3
Record these MAC addresses before you rack the Netcrypt. You may want to make a photo copy of the label before you rack the Netcrypt.
(NOTE: The newer labels may be 1-based; they might have changed it. In the DNCS GUI, the Ethernet Ports of the Netcrypt are definitely 1-based.)
Click the Netcrypt button in the admincon GUI. Select the radio button next to the Netcrypt you are swapping out. This is where you enter MAC ETH A which is the management port. Then in the Navigation Bar on the left, click “Ethernet Ports” This is where you enter the other 4 MAC addresses. These are the video ports of the Netcrypt.
Change the 5 MAC addresses in the Netcrypt GUI and save it. Then power on the new Netcrypt, and let it do bootp.
The “session” command that was captured at the beginning is similar to getting a session count off the front of a QAM before swapping it out, but Netcrypt does not have a front panel display.
Hello, I have configured VPLS on following setup.ios12----CSR1----CSR2---ios13But I can not ping from ios12 to ios13.ios12#ping 184.108.40.206Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 220.127.116.11, timeout is 2 seconds:.....Succes...
Hello All, I am trying to configure optimal route reflector. IOS1 is ebgp neighbor to CSR2 and CSR3. CSR2, CSR3, XRv-RR and XRv3 are part of same AS 123. I have configured optional route reflection on XR-RR. But I do not see any prefix on XRv7.I am n...
we have already installed IOS ROMMON and IOSXE in bootflash But we have a problem in in memory space stby-bootflash to complete upgrade
so please , how i can resolve this problem
Directory of bootfla...
I have a cisco metro boucle: ME3800, cisco 3600, ASR903, ASR920....
so i want from expert cisco that help me :
i want to add a commands that broadcast a template to all router without typing this template conifg ...
Hello All, I have configured following setup. Ebgp + label is configured on all 3 routers. 18.104.22.168/32 is advertised from R1 in bgp.22.214.171.124/32 is advertised from R3 in bgp.R1 received 126.96.36.199/32 through bgp. R1# show bgp ip...