Fail to provision Border Node
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-05-2021 01:19 AM - edited 07-05-2021 01:20 AM
Good Morning ,
I m building a simple SDA fabric and failing to fully provision the border node . The device has been added to the Plug and Play Error tab with the below config related error message ( Please see attachment ).
" %You already have RSA key defined named dnac-sda.% They will be replaced.% The key modulus size is 2048 bits% Generating 2048 bit RSA keys, keys will be non-exportable...[OK](elapsed time was 2 seconds) login local ^% Invalid input detected at'^' marker. "
I have attempted to reset the device without much progress .
Can somebody be advise ? I m a newbie when it comes to SDA .
Thanks in advance
- Labels:
-
SD-Access
