cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
548
Views
5
Helpful
1
Replies
dm2020
Beginner

External Border Redundancy

I have the attached external border topology. For the underlay network we have a link between each border node and each fusion switch and a single link between border nodes. There is an eBGP adjacency over each of the border to fusion links (4 in total) and an IGP adjacency between borders for the underlay

 

What I want to confirm is the need for East-West iBGP peering between the border nodes for each VN if we have adequate North-South eBGP redundancy. Looking at the diagram above, there is an eBGP peering over each link between the border nodes and fusion switches which provides continuous forwarding in the event of a single external link failure. This is automated by DNA Center for each VN. From my understanding, iBGP between borders will only be used in the event that one border loses all of its external links which is an unlikely scenario. DNAC doesn't automate the iBGP peering configuration so I want to avoid the need to manually configure if it’s simply not needed. Is there any reason to configure iBGP in this scenario?

 

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
jedolphi
Cisco Employee

Hello, you are correct, iBGP is not necessary if they are external borders and they will never completely lose connectivity to the external network. This is covered in BRKCRS-3493, https://www.ciscolive.com/global/on-demand-library.html?search=brkcrs-3493#/session/1571888607137001yDeW . Be sure to test all plausible failure scenarios with your final border configuration, as discussed in same presentation. Best regards, Jerome

View solution in original post

1 REPLY 1
jedolphi
Cisco Employee

Hello, you are correct, iBGP is not necessary if they are external borders and they will never completely lose connectivity to the external network. This is covered in BRKCRS-3493, https://www.ciscolive.com/global/on-demand-library.html?search=brkcrs-3493#/session/1571888607137001yDeW . Be sure to test all plausible failure scenarios with your final border configuration, as discussed in same presentation. Best regards, Jerome

View solution in original post

Content for Community-Ad