I've looked at the latest Security-Cisco ASA 55xx stencils on Cisco's website dated 06/May/2013 and they do not contain a visio for the 5516x firewalls. Is there a timeframe on when those will become available?
I too found that any stencils or even any photographs of the 5516x to be oddly elusive among all of Cisco's appliance offerings. I found nothing at all in any of Cisco's documentation. The closest I got was the back panel. Eventually I located one picture from CDW's website of the front of the 5508x which looks identical to the 5516x. I saved it and converted it to a vss file I could use. Unfortunately, this site does not allow me to upload *.vss files, so enjoy this *.png file. I used "Png to Vss Converter 5.3" and had it output to My Shapes folder. Easy pleasy.
Guided workflow allows for automated troubleshooting cases (non-RMA) and RMA creation process for Service Requests (SR) opened for Cisco products.
Less troubleshooting - the IRE (Intelligent RMA Experience) Prediction Engine does ...
1. Asset Recovery EMEAR - Scope2. Cisco Returns Portal – Quick Overview3. Update your RMA – Options and Walkthrough4. POWR Tool and How to Return - Quick guide and Scenarios5. Returned but not closed - Frequent Scenarios6. I cannot return my faulty part. ...
Full analysis if the problem
The root cause behind this problem is the delay in sync between CUCM and CCX.
CCX and CUCM has an automated sync mechanism which might vary from 5 - 10 minutes based on various parameters.
Also there is an option to sync...