Visio Stencil for ISR 4351 and 4331

[sdipippo]

Hello,

My customer is interested in a Visio stencil for the ISR 4351 and 4331 routers. I do not see one after searching quite a few places. Is there an existing one, or can you please create one for each platform?

Looking forward to your prompt response!

Thank you,

Steve

[sdipippo]

Hello,

I would like to know if this request has been acknowledged. Please let me know.

Thanks,

Steve

[sdipippo]

I worked with the team internally and the stencils are up - http://www.cisco.com/c/en/us/products/visio-stencil-listing.html

[mcushman9]

Hello,

I found the stencils for the 4000 series ISRs, but the problem I'm having is that the entire shape is grouped/protected and will not allow the insertion of modules like the other platforms do.  I cannot put in the VWIC module in the 4331 because the cover can't be removed from the shape.  I have tried ungrouping but every single line in the shape (hundreds) gets ungrouped and basically can't be re-grouped in sections.  Is there something I am missing as far as shape protections go or anything?  

Thanks,

Marc

[sdipippo]

Hey Marc,

I went ahead and reached out to the same people who created the stencil for me and asked them to reply directly to this thread. Hopefully they do!

Thanks,

Steve

[michael.jung]

Hi:

This is  a really old post but you don't still have stencil do you?

Thanks!