Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a Cat6509 CatOS 8.1.3, Sup720 MSFC IOS 12.2(14)SX2, and we are having trouble using a linux dhcp server for registration and changing of vlans (Netreg, southwestern flavor). We use MS DHCP on Win2003 servers on 10.140 network for all valns e...
I recently updated an existing Ciscoworks installation to CWLMS 2.2. I am trying to distribute in RME a new ios software image to some devices, and keep getting the following message: "Device Error: Telnet error in connecting to the device. Cannot ...
What version of CSPM supports IDSM blade on 6509? I am having tons of trouble with NT 4.0 SP6a CSPM 2.3.3i interfacing and reporting from my IDSM blade. I do not have any host sensors/appliances currently, just the one blade. The blade is in fact se...
I would like to know what is the latest IOS or OS version I can/should install on a Cat6509 configured with a Sup1A and a MSFC(1) card. Am I running in 'Native' mode?? This chassis has the the following modules installed: 1000BaseX Supervisor ...
We GOT it! Remove the "ip broadcast-address 10.200.255.255" statement on your vlan200 and"ip broadcast-address 10.210.255.255" on vlan 210...in fact you can probablyremove it from all your networks.This is what I think is going on....The client sends...
Thanks for the tips. I found out all my DNS entries got blown away so ciscoworks couldn't reach them properly. After adding back dns entries, found that I was 1 IDU rev behind -- and that IDU 9 corrected problems with pushing ios sw updates to 3500...
Thanks for this info. Are you positive that VMS 2.1 will support the IDSM blade in 6509? I thought I read in some of these posts that it did not support IDSM, but only supported appliance sensors. I am continually frustrated by Cisco announcing ne...
I read this post and I would like a clarification please. What version of CSPM supports IDSM blade on 6509? I am having tons of trouble with NT 4.0 SP6a CSPM 2.3.3i interfacing and reporting from my IDSM blade. I do not have any host sensors/appl...
