Hello, There are devices where they are not getting network connection when its set to static IP. DHCP is working fine but then if we use the same address as DHCP address that we received for static there's no network connection. the SW ports are set...
Hello,is there a firmware path going from 12.2(55)SE to 15.2.4E10(MD) or can we directly upgrade to the recommended version? I did go over the IOS release document but still would like to make sure. Thank you
Hello,I have current firmware on 15.2.2 E7 and trying to do firmware upgrade to 15.2.7 E2 (recommended), is there any firmware hop that is recommended for this upgrade? Thank you,
Hello,I have a WS-C3560X-48P switch in production that has RADIUS setup from windows server 2012 R2. We have disabled the RADIUS authentication from Network Policy server to be able to use local authentication. For some reason, some device or somethi...
Hello,I have upgraded the SG200-26 to 1.3.7.18 but before then the boot code option to upgrade the boot version was greyed out. Is there any reason or solution to that? Im trying to upgrade the firmware on that to 1.4.x but its not taking 1.4.0.88 ve...
So it looks like the link light is on and IP address assigned statically from the excluded range of DHCP. The link light is on but status show not connected. Any solution to that? There's also a server connected with same config (trunk, encap, portfa...
I had issues where it was not taking the .tar file. the error i have pasted below. I am not sure if that meant I didn't have enough memory but even upon researching I couldn't come across anything. I was doing this via TFTP SolarWinds. I also tried d...