Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently have a 1760 with 128M ram and 64m flash running 12.4(15)T14. I have 1 2fxs card and 1 2fxo card. The router will only reconize one card at a time. For example, if the fxs card is in slot 0, it detects the fxs card but not the fxo card. If...
we currently have several offices internationally. Each Office is considered an untrusted site, so we have firewalls between offices. Most of these firewalls started with Pix 6.3 but have been upgraded to 7.2. Many of the rules have been put in place...
I have a 525 running 6.3 setup with 3 interfaces. Inside, branch, and dmz.The ip address range of my Head Office is 10.1.0.0 255.255.0.0 and my branch is 10.2.0.0 255.255.0.0.I have a server in the dmz with an IP address of 10.1.1.12.The firewall has...
We have a remote office with a 5510, and we are trying to access the asa 5510 via the ip address configured on the inside interface (the interface facing the renmote office, not the wan). We can access the outside ip address fine, but cannot access t...
I cannot seem to figure what what the difference is between filters and certfied devices in the NAC CAM interface. Both seem to allow devices to bypass authentication and posture assesment. When would one be perferred over the other?
I have seen that page before. The issue is, when the router starts up, there is no phone calls being made. So from that document, I require no dsp modules. But if I use that page in a different way and I would only like to make 1 phone call, I still...
