Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup my very first ASA5505 and I cannot get it to pass traffic from the inside to the outside. I am not using NAT/PAT. Here is what I have done so far.ASA5505(config)# interface Vlan 1ASA5505(config-if)# nameif insideASA5505(config-if...
I am new pretty new to networking and am trying to understand my orginizations current configs. We have a large hub and spoke network, but my question is for the remote side of the house. On the remote we have 3 seperate networks (2 user and 1 transp...
Mike,Thanks for the quick response. I turned on icmp inspection but still could not get through. I have tried http and https as well with no success. Connected to the outside interface is a HAIPE encryption device that will allow you to GUI into it u...
Just wanted to follow up on the why we don't plug the WAN directly into the PT. One of the engineers told me it is because we use a couple different types of encryption devices that each require a different MTU size. This can sometimes cause an issue...
We try to stick to the STIG's as much as possible. The config above is implemented in a training environment and then adjusted slightly before put into a real world environment. That's when we will modify the access-list, remove telnet, & add authent...
We do not use SPAN as far as I know. I will be honest, I have no idea why we don't do that. The design of our networks and equipment layout comes from the engineering department (well above my pay-grade). I don't see why that wouldn't work. From my p...