Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi Team, is there any way to restart isis process in IOS ? i have tried to clear the clns neighbor but no luck . ISIS sequence number has been reached maximum "0xFFFFFFFF"Router-1#show processes cpu sortedCPU utilization for five seconds: 99%/0%; one...
hi Team, i have configured an ACL to reject the targeted Hello from LDP neighbor, but despite of applying ACL, why LDP session TLDP session is showing up. RP/0/RSP0/CPU0:R1#show access-lists UDP Tue Jul 30 ...
Hi Team, why Below BGP prefix is getting Advertised to Multiple Peers. it's not best route and not in routing table. Please help on this.RP/0/RP1/CPU0:ASR9K-R1#show bgp 192.168.0.0/24Wed Jun 5 17:37:49.726 istBGP routing table entry for 192.168.0.0/2...
Hi Team, In ACI fabric, if Host MAC or IP got flushed from ACI fabric , is there any way to check from where it was getting learned earlier and when it got flushed ? Thanks Sunil Kumar
Hi Team, i have topology of three routers (R1----->R2------>R3) R1 and R3 are acting as PE device while R2 is RR. Please confirm whether below behavior is normal or not. R1 is receiving prefix 1.1.1.128/25 from R3 with RD of 1234:11 and VPN Label 240...
Hi , as we can see in the output, counters are increasing it means LDP Hello's are hitting on ACL . but not sure why it's not denying it. RP/0/RSP0/CPU0:R1#show access-lists UDP Tue Jul 30 16:28:26.728 ISTip...
Hi MHM , can you please confirm what is the behavior of below command when applied to LDP and why TLDP is showing up. mpls ldp address-family ipv4 discovery targeted-hello accept from xxxxxx BR://Sunil Kumar
