Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,When we do self diagnostic test for WAE connected to the 6500 switch i get warning as below. Due to this alert there is no major acceleration benfits by the WAASTest WARN [tfo] WARN ASYMMETRIC Asymmetric routing is seen in the devi...
Hi All,We are seeing Minor alarm unsupported_client in some of the WAE. When i did alarm detail support it shows no action required. But I would like to understand why the alarm is created. We have not seen in the previous code 4.1.5f.abcdwa1#sh al d...
Hi All,We have an WAE with code 4.2.3c recently upgraded from 4.1.5f. We were able to telnet to device until there was an alarm "disk_failure critical alarm " which was generated. We are able to ping the device and we are getting the login prompt but...
Hi All,We upgraded the WAE from 4.1.5f to 4.2.3c. We did not disable WCCP in the IOS router before and after the upgarde so the Mask assignment remained the same ( 0x1741).We have the situtaion where , we need to add a new WAE with code with code 4.2...
Hi Bhavin,I tried to reproduce the issue again and i have the Logs which shows incorrect TACACS key in the logs in both ACS server and in the WAAS box.ACS Log :04/26/2011,00:38:14,Authen failed,,Default Group (No Access),,Key Mismatch,,,,10.132.5.193...
Hi Bhavin,,Thanks again, I checked my TACACS key and it does not have any special charcter and less than 12 character. I just downgraded the box to 4.1.5f and created the disk issue in my lab and i was able to login with no issues. i upgraded to 4.2....
Hi Bhavin,Thanks for your reply. The Box was working fine and it lost the raid controller and i am not able to telnet. Even when i take console i need to remove the Network cables for Local passwords to work.In the previous version it was not the cas...
