Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all I am trying to build a VXLAN tunnel between C9396PX and C93180YC-FX. when i run a "show nve peer" on the C93180YC-FX, it shows that the peer (which is a C93180YC-FX) is up and i am learning mac address over the nve interface. When i run the s...
ISIS for IPv4 only = Old TLVs = narrow metrics only = Single stackISIS for IPv4 and IPv6 = Old and new TLVs = narrow and wide metrics = dual stackTLVs used to advertise reachability to IPv6 prefixes use wide metrics by default, so enabling ISIS IPv...
Hi SergiuNo i have not tried that yet, i though it was not necessary since both VTEP peers share the same secondary loopback IP. Do you mean having them connected like in the attached diagram (green L3 links)? I will connect all of them to the underl...
Hi Sergiu I am running flood and learn. i have shared the diagram and the nve configs below. On one VTEP, the nve peer shows up and i am learning MACs from the remote VTEP. But on that remote VTEP which is a C9396PX, there is no peer showing up and ...
Hi Sergiu I am running flood and learn. i have shared the diagram and the nve configs below, on one VTEP, the nve peers shows up and i am learning MACs from the remote VTEP, but on that remote VTEP which is a C9396PX, there is no peer showing up and ...