Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys,
Before I start I would like to say that I am New to Cisco and never configure any access point or router before. I only used Linksys and TP link router and access point before. So please advise me as a new person.
I heard a lot of good...
You my friend are the "STAR". My AP is not only transmitting wifi signals its also faster than I thought.
Now tell me how to recover an another AP which was turn off while updating the firmware and now there is only Red Flashing light.
Thanks Rasika for your reply,
What if I create a Config.txt file by copy and paste this text and make the changes to SSID and password and upload it through GUI interface, will it help?
I have the access to AP through Telnet and SSH. but when I type...