Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,How to configure 802.1x on Ubuntu endpoint to enable 802.1x on WLAN to apply low Impact mode for wireless devices?I already applied the configuration on wired devices but I can't do that on wireless devices from an endpoint side.
I tried to apply low impact mode on wired non-domain devices but connected to my network how to authenticate them?And if I apply the ACL on the switch on these devices is it enough or not?
I'm trying to deploy low impact mode on Cisco ISE but I don't know the requirements should I use on network devices and client-side.and How can I install a certificate on Linux device to identify Cisco ISE?
Hello,I'm trying to deploy low impact mode on Cisco ISE but I don't know the requirements should I use on network devices and client-side.and How can I install a certificate on Linux device to identify Cisco ISE?
