Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello community,
I refer to this (quite old) discussion and this answer which is not that old... But I have an ASA with software version 9.9(2)80. I would like to send debug messages via syslog even after ssh logout.
The answer tells that one should ...
"Note that this problem occurs even if you have a twice NAT rule; although the NAT rule must match both the source and destination addresses, the proxy ARP decision is made only on the “source” address" -> This part of the docs completely bricked my ...
Ok, now it magically works. No idea what the problem was. But nevertheless, the output is
debug crypto ipsec enabled at level 255debug crypto ikev2 protocol enabled at level 255debug crypto ikev2 platform enabled at level 255debug crypto ike-common ...
Yes, this command is persistent over different ssh sessions. And I also have issued the logging trap debug command. Now I have debug logs arriving on my syslog server.
I'd like to use additional debug commands. Their output should then arrive as %ASA...
