Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I hope you can help me. I have 2 switches SG350, and I want to propagate the VLANS I create in one of them to the other, I know that in this model there is no VTP domain to do that. I found out that there is a similar command that does that,...
Thank You, Apologies but I hadn´t come to the office until now, because of the contingency. Finally I had updated both switches to 2.5.0.92, but it did not work, no VLANs were propagated. about the option of disabling auto smart port, Should this be ...
Apologies for replaying late, but with the contingency I´ve been working in some other stuff, today I reboot both switch 2 but it did not work, the vlans created in switch 1 did not propagate. Do you know which is the last firmware for these switches...
Thanks aturawat please correct me if I am wrong So this is what I should do in order to propagate the velans from the Switch 1 to siwtch 2,1.- Create all the vlans in switch 12.- Enable GVRP at global config in switch 13.- Enable GVRP in the port th...
Thanks aturawat, actually that is the way I configured the switches, GVRP is enabled in both interfaces, both ports are in trunk mode, and GVRP is enabled en global configuration, but ir is not working,this is the configurations in the ports of each ...
