Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,i have some questions about NCM.Is this software running as standalone system, or must it integrated in LMS or another Application?I found some minimum hardware requirement, but what is the maximum limit of devices which can be handledwith one...
Hi all,i have a switch (WS-C3560-8PC) Cisco IOS Software, C3560 Software (C3560-IPBASEK9-M), Version 12.2(50)SE3, RELEASE SOFTWARE (fc1)where I get no values when asking the spanning tree mib (1.3.6.1.2.1.17.2).But this switch is configured like all ...
Hello,we are using Spectrum for monitoring, and have the problem, that spectrum ask every 5 minutes 3 mib variable from the devices.These are ifStackLastChange, ifTableLastChange and ifNumber. When some value is changed, the devices will complete red...
Hello,we have some switches (c3750) which have all VTY lines busy. We know why, because we are using a tool which works not correct. I tried the following way, but i cannot clear any of these lines. When i do a snmpwalk to tslineSesAddr i see 16 Ip-a...
We have a switch C3750 V12.2(44)SE which has to many ssh session, and we cannot access anymore to this switch, because telnet is disabled. SNMP access is possible. Is it possible to kill the ssh processes or is there another solution available to get...
Hi jadavis,thank you for the detailed information. However i have still some questions.What do you think about virtualisation, or do you think it is better to havethe software running on a standalone machine.The advantage of virtualisation what i see...
This is the version from the router:Cisco Internetwork Operating System SoftwareIOS (tm) s72033_rp Software (s72033_rp-PK9SV-M), Version 12.2(18)SXD7b, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2006 b...
This is configured on the router:rtr 1005type echo protocol ipIcmpEcho 1.1.1.1 source-ipaddr 2.2.2.2threshold 10timeout 200rtr schedule 1005 life forever start-time now
This helps me very much.I have done a sh rtr operational-state, and see the same values, which are in the snmpwalk. But have you any idea, why is sometime the value 0.Perhaps i do the query in the same moment, when the measure is started. But how can...
I have done an snmpwalk and a grep for the value 12345, i didnot find something. Then i configure a rtr 12345 on the router, and did again a snmpwalk and a grep for 12345, and find only this 12345 in the rttmonmib. But the names which returns are no...
