Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a client who stores large volumes of video footage archives. They are concerned that there may be impact on their archives from WIFI. We are in the process of performing an onsite survey (for AP placement) and they are now requesting any infor...
WLC - Cisco 4402OS - 7.0.98.0LWAPs - Cisco 3502ePhones - 7925GCurrently the phones are associating and authenticating, being assigned an IP, and this is where we run into issues. If you try a "link test" from the WLC on the client and it fails. If ...
I setup a 4402 this evening an everything was going great. The unit had v4.2.130.0, I need to upgrade to v6.0.182.0.The upgrade guide requires the following upgrade path v4.2.130.0 > v4.2.176.0 > v6.0.182.0.I began with the upgrade to .176 and ever...
Serge,Thank you for the reply.The IPT engineers stated the following:"We couldn't make or receive calls, we had gotten Network busy messages"I'm not sure how helpful this is, but my understanding is they were able to make a call this morning. I had s...
After regaining access to the Net Meeting machine, and consoling into the WLC all configurations looked good, but for some reason Port 1 was enabled but reporting not connected.I performed a factory reset on the WLC and returned it to factory setting...
I just have to wait until the moring and have the local contact unlock the Net Meeting machine and I will have access to the console again. I think in the future I will setup the management port until the unit is upgraded and fully functional... less...
No, I didn't touch the boot strap, as per the instructions of a co-worker. I was wondering if this could be my issue.I am unfortunately in NYC and the WLC is located in Ottawa, Canada, and no one is available patch the management port. Our " Standard...
