About qnguyen8

qnguyen8 · 12-23-2004

I am trying a new code, 12.3.11T2 on our routers and every night when traffic is low, the spoke router with the new code on it would lose it EIGRP adjacencies. All the other spoke that are running 12.3.6a run fine. And the only way to get the neigh...

qnguyen8 · 07-05-2006

Thanks. Any to any connectivity is working, hopefully they register to the CMs. Was Cisco able to verify the compatability issue?

qnguyen8 · 06-30-2006

I am having the same issue, did you assign then all /32 mask or did you make then /30 between the two gig ports and the FE ports?

qnguyen8 · 01-19-2005

I'm also running advsecurity. With my current config, things are running stable. RDP and other applications work fine. Are you running DSL on any of the sites?Also, TAC recommended that it there were connectivity problems or a lot of output drops, ...

qnguyen8 · 01-18-2005

I didn't see much of a performance hit but, you can enable cef. You just need to take your IP MTU size down to 1400 on both hub and spoke tunnel interfaces and that should stop the wedging problem.

qnguyen8 · 01-17-2005

I actually got all this stabalized with TAC. The 12.3.(12.10) code was posted for me twice. The first one had a bad checksum. The second one had had some "bad magic number" boot up errors and while it was up, had "CHUNKBADMAGIC" errors, TACACs als...

Member Since	‎10-23-2001 01:47 PM
Date Last Visited	‎05-31-2023 12:02 AM
Posts	15

User Statistics

User Activity

Losing EIGRP adjacencies w/ DMVPN

Re: How to configure backplane interfaces on SVC-CMM-6T1 module

Re: How to configure backplane interfaces on SVC-CMM-6T1 module

Re: Losing EIGRP adjacencies w/ DMVPN

Re: Losing EIGRP adjacencies w/ DMVPN

Re: Losing EIGRP adjacencies w/ DMVPN