Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I've been looking for the 5525-X end or life/end of sale and not found consistent results. The cisco.com page indicates it is available. There is a link for the EOL, but it fails with an error. I need to know the true EoL, EoS, and end of s...
Hello,
I'm working with a customer who has a pair of Nexus 9300 for a core switch. They have configured interface mgmt0 as vrf member management, and applied an IPv4 address. They have recently added Meraki MX to the environment to service their ...
I've been asked to configure an ASA 9.x routed mode with two DMZs. An APP server currently sitting on the internet with two outside interfaces, and one inside interface should span (bridge) these two DMZs Inside on on DMZ, outside on another. The cur...
Hello, I need to configure an ASA 5545 as a pass-through filter for devices (two, with one inside, and two outside interfaces each) that are connected directly to the internet. They do not want to use Firepower. I have configured one-to one NATs f...
Hello, I'm working with a network I inherited. They have two WAN providers; one has one eigrp assigned internally, the second has two assigned internally. The Data center cores are configured with five different instances (#) of eigrp, and an ospf...
Seb, Thanks for the reply. Am I to understand that the value of 250 then makes that route least favorite over the zero value found in the mgmt0 interface? I'm hoping to discourage using the same subnet as a management vrf and a production VL...
I have been experimenting with transparent mode. I have a lab setup which I've been able to apply an ACL to filter the requested ports from hosts on the inside network to the gateway outside. I wonder if this might be the way to go? I applied the sam...
Hello, Thanks for the reply. The setup they have now just connects all the device outside interfaces to individual ports on a cable modem. They would prefer not to use an additional switch, hence the BVI(s). I've used that to basically create a sw...
hello, Sorry I let this thread go so long. For their internal network (not partners) there are 10 different OSPF AS #, and 7 different EIGRP AS # for nine sites. Two sites have the same OSPF #, and two sites have two different OSPF #. All of these...
