Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have a new ASA5508 where i installed the new FTD 6.2
I think the interface looks OK, but i cant find out how to monitor the site2site VPN
Can anyone tell me o i can see status of the VPN tunnels, and how to see some log if i have a tunnel wit...
HiI need to create a number of bridges on a installation, where i need to use some exsisting 5GHZ antennasI can only connect one 5Ghz antenna on each Access-point.What is the Max link speed then using a single Antenna - in the best signal senario?/La...
I have project where I have 24 Cisco 2602 AP as a wireless bridge. (12 pcs root bridge and 12 pcs of non-root)I would like to use "whatsup Gold" to monitor the RSSI on my wireless links.I have been told that if information is availeble through SNMP, ...
HelloI had maked a sight survey whith a 1231 AP, and 2 2,2dc antannas.now is my qustion - is there any problem, to convert to 1242 whith 2 2.2dBi/2.4Ghz,5.0dBi/5GHz DualBand Dipole AntennaIs the wireless range of these produckts the same??and can a 5...
Hi,
I use the new FTD 6.2
new feature en FTD 6.2 is site2site VPN - and can also create the VPN tunnel, but cant find out where to monitor the status of the VPN.
Can you please veryfy the following:1.3.6.1.4.1.9.9.273.1.3.1.1. + 3 +2 (RSSI+A)SSID test:116.101.115.116MAC: 8c705aff58fo140.112.90.255.88.240Full OID:1.3.6.1.4.1.9.9.273.1.3.1.1.3.2.116.101.115.116.140.112.90.255.88.240you have the number 5 after t...
Hi WillTkank you for the information.if i use the Paessler SNMP tester, an send the OID 1.3.6.1.4.1.9.9.273.1.3.1.1.3 to the access-point it will return:----------------------- New Test -----------------------Paessler SNMP Tester 5.121-11-2013 20:3...
Hi WillWhat firmware are you using.I just talked to cisco TAG because "1.3.6.1.4.1.9.9.273.1.3.1.1.3" is not working on my AP.AIRESPACE-WIRELESS-MIB is not supported on 2602.Lars