Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am looking for what are the documents/Best Practices and Recommendations for : 1- Using a shared ACI network infrastructure for the "production" and "backup/restore" traffic2- 1- Using a dedicated ACI network infrastructure for the "production" ...
Hi, We have 2 Edge Routers and 3 ISP connections, which are connected to both of these routers, as the image bellow.Now we want to have symmetric traffic. Our Provider Independent IP Address is X.X.X.X/22, which we have split it to 4 X /24 addresses....
Hi,Is there any good solution with SD-WAN on Internet Edge Routers for controlling the outgoing traffic to the service providers from the customer side? (except using PBR solution)And how does it exactly work ? We want each buildings send/receive tra...
A question about Cisco 3850 TCAM or Nexus 3064 TCAM The entry of the TCAM for PBR, when configuring it, what does it exactly mean?The entry means that ?: "The number of source ip subnets that we are allowing in the access list that will match the PBR...
Hi,Is there any solution (except using PBR) for controlling the outgoing traffic to the service providers from our side?We want each buildings send/receive traffic go through each provider, while all providers can act as backup for others. For contro...
Hi Mr.Richard,For the VDOM,my idea was to split each subnet(customer) that is behind the firewall, in a separate VDOM, and send the outgoing route to the specific router that is handling the service provider connection. So, the route path selection ...
Hi,Maybe i can make this look simple.We have 2 Edge Routers and 3 ISP connections, which are connected to both of these routers, as the image above.Now we want to have symmetric traffic. Our Provider Independent IP Address is X.X.X.X/22, which we hav...
Thanks for your information@Richard Burts @Giuseppe Larosa Actually, i posted another question in the following link, regarding to this post (performance information about the 3850 or the 3064 in processing PBR. ) and also about the meaning of the T...
Dear Mr.Richard,Thanks. For 2 reasons: 1- Because of the CPU load that PBR usually puts on the routers (L3 switches) which are located at the edge(the routers that are doing BGP at the Edge)2- It Gets complicated when there are 2 routers(L3 switches...
