Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just logged into new client's firewall
And I came across the above access list applied to the outside interface inbound.
Does that mean I am allowing everyone one on every port in?
I have a synchronous 10 Mb connection to my isp which I have conneted to a CISCO asa 5510. I have done a lot of testing and there is a very noticable difference in my upload/dowload speeds.When I connect a laptop directly to the Cable from my ISP's e...
access-group outside_in in interface Outside
):0
Like I said in original post in outside interface
I posted this thinking in can't be correct in thinking that FW was open to outside from any ip
but it looks like it is and was just wanting a confirma...
Guys thank for you inputs,I have tested some other things, I looked at those best practices posted by Sean and even tried the the mss-exceed allow fix that I have used on dhcp Cable modems plugged into ASA(s) and still the same results. No Http in t...
No I have made sure that interface is set to duplex and have seen it show full form sho int command. I have set it to Auto with the same results again.I work in the Tri-state area and normally would see this where we would do cuts over to Light_path....
Guys here is the actual config that I was able to get working. Notice here unlike the PIX we have introduced virtual interfaces using Vlans. I was able to figured it out.Thanks again
